formally typical historical interpretation of GPLv2.

% FIXME-LATER: perhaps in enforcement section, but maybe here, note about

% ``slow down'' on source downloads being a compliance problem. 

Furthermore, under GPLv3~\S6(d), distributors may charge for the conveyed

object code; however, those who pay to obtain the object code must be given

equivalent and gratis access to obtain the CCS.  (If distributors convey the

object code gratis, distributors must likewise make CCS available without

charge.)  Those who do not obtain the object code from that distributors

(perhaps because they choose not to pay the fee for object code) are outside

the scope of the provision; distributors are under no specific obligation to

give CCS to someone who has not purchased an object code download under

GPLv3~\S6(d).  (Note: this does not change nor impact any obligations under

GPLv3~\S6(b)(2); GPLv3~\S6(d) is a wholly different provision.)

\subsection{GPLv3~\S6(e): Peer-to-Peer Sharing Networks}

Certain decentralized forms of peer-to-peer file sharing present a challenge

to the unidirectional view of distribution that is implicit in GPLv2 and

Draft 1 of GPLv3.  Identification of an upstream/downstream link in

BitTorrent distribution is neither straightforward nor reasonable; such

distribution is multidirectional, cooperative and anonymous.  In peer-to-peer

distribution systems, participants act both as transmitters and recipients of

blocks of a particular file, but they perceive the experience merely as users

and receivers, and not as distributors in any conventional sense.  At any

given moment of time, most peers will not have the complete file.

Meanwhile, GPLv3~\S6(d) permits distribution of a work in object code form

over a network, provided that the distributor offers equivalent access to

copy the Corresponding Source Code ``in the same way through the same

place''.  This wording might be interpreted to permit peer-to-peer

distribution of binaries \textit{if} they are packaged together with the CCS,

but such packaging impractical, for at least three reasons.  First, even if

the CCS is packaged with the object code, it will only be available to a

non-seeding peer at the end of the distribution process, but the peer will

already have been providing parts of the binary to others in the network.

Second, in practice, peer-to-peer forms of transmission are poorly suited

means for distributing CCS.  In large distributions, packaging CCS with the

object code may result in a substantial increase in file size and

transmission time.  Third, in current practice, CCS packages themselves tend

\textit{not} to be transmitted through BitTorrent --- owing to reduced demand

-- thus, there generally will be too few participants downloading the same

source package at the same time to enable effective seeding and distribution.

GPLv3~\S6(e) addresses this issues.  If a licensee conveys such a work of

object code using peer-to-peer transmission, that licensee is in compliance

with GPLv3~\S6 if the licensee informs other peers where the object code and

its CCS are publicly available at no charge under subsection GPLv3~\S6(d).

The CCS therefore need not be provided through the peer-to-peer system that

was used for providing the binary.

Second, GPLv3\S9 also clarifies that ancillary propagation of a covered work

that occurs as part of the process of peer-to-peer file transmission does not

require acceptance, just as mere receipt and execution of the Program does

not require acceptance.  Such ancillary propagation is permitted without

limitation or further obligation.

% FIXME-LATER: Would be nice to explain much more about interactions between

% the various options of GPLv3~\S6(a-e), which might all be in play at once!

\subsection{User Products, Installation Information and Device Lock-Down}

As discussed in \S~\ref{GPLv3-drm} of this tutorial, GPLv3 seeks thwart

technical measures such as signature checks in hardware to prevent

modification of GPLed software on a device.

To address this issue, GPLv3~\S6 requires that parties distributing object

code provide recipients with the source code through certain means.  When

those distributors pass on the CCS, they are also required to pass on any

information or data necessary to install modified software on the particular

device that included it.  (This strategy is not unlike that used in LGPLv2.1

to enable users to link proprietary programs to modified libraries.)

% FIXME-LATER: LGPLv2.1 section should talk about this explicitly and this

%              should be a forward reference here

\subsubsection{User Products}

\label{user-product}

The scope of these requirements are narrow.  GPLv3~\S6 introduces the concept

of a ``User Product'', which includes devices that are sold for personal,

family, or household use.  Distributors are only required to provide

Installation Information when they convey object code in a User Product.

In brief, the right to convey object code in a defined class of ``User

Products,'' under certain circumstances, on providing whatever information is

required to enable a recipient to replace the object code with a functioning

modified version.

This was a compromise that was difficult for the FSF to agree to during the

GPLv3 drafting process.  However, companies and governments that use

specialized or enterprise-level computer facilities reported that they

actually \textit{want} their systems not to be under their own control.

Rather than agreeing to this as a concession, or bowing to pressure, they ask

here, since the main problem lies elsewhere.

While imposing technical barriers to modification is wrong regardless of

circumstances, the areas where restricted devices are of the greatest

practical concern today fall within the User Product definition.  Most, if

not all, technically-restricted devices running GPL-covered programs are

consumer electronics devices.  Moreover, the disparity in clout between the

manufacturers and these users makes it difficult for the users to reject

technical restrictions through their weak and unorganized market power.  Even

limited to User Products, this provision addresses the fundamental problem.

% FIXME-LATER: link \href to USC 2301

The core of the User Product definition is a subdefinition of ``consumer

product'' adapted from the Magnuson-Moss Warranty Act, a federal

consumer protection law in the USA found in 15~USC~\S2301: ``any tangible

personal property which is normally used for personal, family, or household

purposes.''  The USA has had three decades of experience of liberal

judicial and administrative interpretation of this definition in a manner

favorable to consumer rights.\footnote{The Magnuson-Moss consumer product

  definition itself has been influential in the USA and Canada, having been

  adopted in several state and provincial consumer protection laws.}

Ideally, this body of interpretation\footnote{The FSF, however, was very

  clear that incorporation of such legal interpretation was in no way

  intended work as a general choice of USA law for GPLv3.} will guide

interpretation of the consumer product subdefinition in GPLv3~\S6, and this

will hopefully provide a degree of legal certainty advantageous to device

manufacturers and downstream licensees alike.

One well-established interpretive principle under Magnuson-Moss is that

ambiguities are resolved in favor of coverage.  That is, in cases where

it is not clear whether a product falls under the definition of consumer

product, the product will be treated as a consumer product.\footnote{16

CFR~\S\ 700.1(a); \textit{McFadden v.~Dryvit Systems, Inc.}, 54

UCC~Rep.~Serv.2d 934 (D.~Ore.~2004).}  Moreover, for a given product,

``normally used'' is understood to refer to the typical use of that type

of product, rather than a particular use by a particular buyer.

Products that are commonly used for personal as well as commercial

purposes are consumer products, even if the person invoking rights is a

commercial entity intending to use the product for commercial

purposes.\footnote{16 CFR \S \ 700.1(a).  Numerous court decisions

interpreting Magnuson-Moss are in accord; see, e.g., \textit{Stroebner

Motors, Inc.~v.~Automobili Lamborghini S.p.A.}, 459 F.~Supp.2d 1028,

1033 (D.~Hawaii 2006).}  Even a small amount of ``normal'' personal use

is enough to cause an entire product line to be treated as a consumer

product under Magnuson-Moss\footnote{\textit{Tandy Corp.~v.~Marymac

Industries, Inc.}, 213 U.S.P.Q.~702 (S.D.~Tex.~1981). In this case, the

court concluded that TRS-80 microcomputers were consumer products, where

such computers were designed and advertised for a variety of users,

including small businesses and schools, and had only recently been

promoted for use in the home.}.

However, Magnuson-Moss is not a perfect fit because in the area of components

of dwellings, the settled interpretation under Magnuson-Moss underinclusive.

Depending on how such components are manufactured or sold, they may or may

not be considered Magnuson-Moss consumer products.\footnote{Building

  materials that are purchased directly by a consumer from a retailer, for

  improving or modifying an existing dwelling, are consumer products under

  Magnuson-Moss, but building materials that are integral component parts of

  the structure of a dwelling at the time that the consumer buys the dwelling

  are not consumer products. 16 C.F.R.~\S\S~700.1(c)--(f); Federal Trade

  Commission, Final Action Concerning Review of Interpretations of

  Magnuson-Moss Warranty Act, 64 Fed.~Reg.~19,700 (April 22, 1999); see also,

  e.g., \textit{McFadden}, 54 U.C.C.~Rep.~Serv.2d at 934.}  Therefore, GPLv3

defines User Products as a superset of consumer products that also includes

``anything designed or sold for incorporation into a dwelling.''

Thus, the three sentences in the center of GPLv3's User Product definition

encapsulate the judicial and administrative principles established over the

past three decades in the USA concerning the Magnuson-Moss consumer product

definition.  First, it states that doubtful cases are resolved in favor of

coverage under the definition.  Second, it indicate that the words ``normally

used'' in the consumer product definition refer to a typical or common use of

a class of product, and not the status of a particular user or expected or

actual uses by a particular user.  Third, it clearly states that the

existence of substantial non-consumer uses of a product does not negate a

determination that it is a consumer product, unless such non-consumer uses

represent the only significant mode of use of that product.

It should be clear from these added sentences that it is the general mode of

use of a product that determines objectively whether or not it is a consumer

product.  One could not escape the effects of the User Products provisions by

labeling what is demonstrably a consumer product in ways that suggest it is

``for professionals'', for example.

\subsubsection{Installation Information}

With the User Products definition complete,  The ``Installation Information''

definition uses that to define what those receiving object code inside a User

Product must receive.

Installation Information is information that is ``required to install and

execute modified versions of a covered work \dots from a modified version of

its'' CCS, in the same User Product for which the covered work is conveyed.

GPLv3 provides guidance concerning how much information must be provided: it